Reorient or relocate the receiving antenna. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. WARNING : This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm.įor more information go to This product meets and complies with required Federal product guidelines. this device must accept any interference received, including interference that may cause undesired operation. 
this device may not cause harmful interference, and. Operation is subject to the following two conditions: This device complies with Part 15 of the FCC rules. Specifications are subject to change without notice. 
Repeatedley press the CPI button to change the cursor speed (High, Medium, Low).įor Warranty Information and the most up-to-date version of this User’s Guide, go to: Copyright © 2021 Digital Products International (DPI, Inc.).Īll other trademarks appearing herein are the property of their respective owners. The CPI button controls how quickly the mouse cursor moves on your monitor. Wait a few seconds and the mouse will be ready to use.Plug the USB Receiver into a USB port on your PC or Laptop.To begin using the mouse, power on the mouse on by sliding the Power switch to the ON position.Note: This mouse does not require any drivers, it is ready to use when the receiver is plugged in. Slide the Power Switch to the ON position to power on the mouse.
To power the mouse insert 2 AAA batteries (not included).
0 kommentar(er)
